• Table of contents
• Deployment
  • Upload properties files
    • ws-mimic
    • ecosway-adaptor
    • ws-status
  • Upload WAR/JAR file

Deployment¶

Prerequisite:

• Completed Installation section
• Completed Configuration section

This section describes how to deploy components/modules to the servers.

Below table summarizes the deployment's tasks:

Component	Type	Target
ecwyconnector	WAR	Dot Com Mall
ecosway-adaptor	JAR	US Mall
ws-mimic	WAR	US Mall / QueueSystem
ws-status	WAR	US Mall

In general, this deployment task involves 2 parts:

1. upload the relevant properties files
2. upload the WAR or JAR file

All of the properties files can be found in SVN repository:

http://192.168.2.13:50000/svn/qconnector/trunk/qconnector-config

Upload properties files¶

This section is dedicated for the first time deployment only. For the subsequent deployment, you should update the existing properties files if needed.

All of the properties files should store in the directory:

/data/qconnector

ws-mimic¶

List of the properties files to be uploaded:

• Note: replace {environment} with either production (for production environment) or development (for development environment)
  • application.properties - http://192.168.2.13:50000/svn/qconnector/trunk/qconnector-config/{environment}/ws-mimic/properties/application.properties
  • jndi-factory.properties - http://192.168.2.13:50000/svn/qconnector/trunk/qconnector-config/{environment}/ws-mimic/properties/jndi-factory.properties

Steps:

1. see the Deployment section for the deployment target
2. upload the following files to /data/qconnector/ws-mimic/ directory via ftp or sftp:
   • application.properties
   • jndi-factory.properties
3. make sure everyone has the read-access to the above files
4. done

ecosway-adaptor¶

List of the properties files to be uploaded:

• Note: replace {environment} with either production (for production environment) or development (for development environment)
  • application.properties - http://192.168.2.13:50000/svn/qconnector/trunk/qconnector-config/{environment}/ecosway-adaptor/properties/application.properties
  • database.properties - http://192.168.2.13:50000/svn/qconnector/trunk/qconnector-config/{environment}/ecosway-adaptor/properties/database.properties
  • registration/template.properties - http://192.168.2.13:50000/svn/qconnector/trunk/qconnector-config/{environment}/ecosway-adaptor/properties/registration/template.properties

Steps:

1. see the Deployment section for the deployment target
2. upload the following file(s) to /data/qconnector/ecosway-adaptor/ directory via ftp or sftp:
   • application.properties
   • database.properties
3. upload the following file(s) to /data/qconnector/ecosway-adaptor/registration/ directory via ftp or sftp:
   • template.properties
4. make sure everyone has the read-access to the above files
5. done

ws-status¶

List of the properties files to be uploaded:

• Note: replace {environment} with either production (for production environment) or development (for development environment)
  • application.properties - http://192.168.2.13:50000/svn/qconnector/trunk/qconnector-config/{environment}/ws-status/properties/database.properties

Steps:

1. see the Deployment section for the deployment target
2. upload the following file(s) to /data/qconnector/ws-status/ directory via ftp or sftp:
   • database.properties
3. make sure everyone has the read-access to the above files
4. done

Upload WAR/JAR file¶